Deutsch
Further information
| Operational modes: | DCC 14, 28, 128 speed steps |
| DCC long and short addresses | |
| DCC traction address (Consist Mode) | |
| DCC LGB pulse control | |
| Automatic speed step detection | |
| Lenz® LG 100, ROCO® brake unit | |
| Lenz® ABC brake unit | |
| ZIMO® HLU commands | |
| DC analogue operation | |
| Motorola® 14 speed steps | |
| Motorola® 28 speed steps | |
| Motorola® address 1 - 80 | |
| Motorola® address 1 - 127 | |
| Motorola® address 1 - 255 | |
| M4 data protocol (mfx® compatible) | |
| Selectrix® | |
| Märklin® brake unit | |
| AC analogue operation | |
| Automatic detection of operational mode | |
| Throttle: | DC and coreless motors, AC motors with magnet |
| 40,00 kHz PWM frequency | |
| Load control in digital operation | |
| Load control in analogue operation | |
| Adj. start / maximum speed in analogue operation | |
| Mass simulation for 14 speed step operation | |
| Autotune function for load control | |
| DDC (Dynamic Drive Control) | |
| 4,0A continious motor current | |
| Short circuit protection | |
| Function outputs: | 8 amplified function outputs with short-circuit protection |
| 500mA current of each output | |
| 4 servo outputs | |
| Separate output dimming | |
| Light effects like Blinking lights, Marslight, Fire box flickering etc. | |
| Time-controlled function outputs | |
| Function Mapping V4.0 ESU (F0 - F28) | |
| Function Mapping M4® compatible | |
| Shunting mode (de-selectable) | |
| ABV (de-selectable) | |
| Serial protocol (for SUSI) | |
| Programming | |
| DCC service mode programming modes: | (Register Mode, Address Only, Direct Mode) |
| DCC POM (Programming On the Main) | |
| Programming mode for Märklin® 6021 | |
| M4® configuration on the main track | |
| Specials: | M4® feedback system |
| RailCom® feedback system | |
| RailComPlus® automatic recognition | |
| Storage of current operational state (memory) | |
| Motorola® wrong-direction bit | |
| Integrated »PowerPack« energy storage | |
| Dimensions in mm: | 55,0x25,0x10 |
The decoder can be used on Selectrix® layouts. Programming in DCC mode only. Programming with exclusive Selectrix® devices not possible.